Agilent Technologies G3485A Installation Instructions

Third detector box for the 7890a gas chromatograph

Download this manual

Parts Supplied

Table 1

Description

Third detector box assembly

Flow module back-up plate

Screw, M4 × 0.7 25mm (2-for flow frame top, 1-for flow module backup plate)

Screw, machine, M4 × 0.7 12mm (4-for flow frame bottom, 3- for flow module

backup plate)

Agilent G3485A Third Detector Box

For the Agilent 7890A Gas Chromatograph

Installation Instructions

Parts supplied

Agilent Technologies

Quantity

Page 1 Agilent G3485A Third Detector Box For the Agilent 7890A Gas Chromatograph Installation Instructions Parts Supplied Table 1 Parts supplied Description Quantity Third detector box assembly Flow module back-up plate Screw, M4 × 0.7 25mm (2-for flow frame top, 1-for flow module backup plate) Screw, machine, M4 ×...
Page 2 Remove the left side cover by loosening the two top screws, sliding the panel towards rear, and lifting the cover off. This cover and fastening screws will no longer be used when the G3485A Third Detector Box is installed on the GC.
Page 3 Agilent G3485A Third Detector Box Attach the side bracket of the flow module back-up plate to the stand-off using an M4 x 25 mm screw. Attach the previously removed gray label plate to the front bezel. Attach the third detector flow frame...