NEC NEAX 2000 IPS Maintenance Manual page 99

NOTE: To use Hyper Terminal, select File
• To collect the fault logs and call logs, be sure to set the MP card to on-line mode (set SW3 switch
to 0).
(2) Conditions of fault log collection
• By collecting fault logs, you can specify the reset causes and reset time.
• By collecting fault logs, you can calculate the number of sending control packets, the number of re-
sending control packets, the number of failed re-sending control packets, the number of received
control packets, the received error control packets, and the error number of control sequences.
• The fault logs are collected by the following timing.
term
- When D IPs or IP-CSs login to the system, and when the IP-PAD card is in online status
- When you set the office data for fault logs collection (CMEA Y=6>11) from MAT/CAT
• The output format of fault logs is as follows.
21234567 04/09/13 12:01:40
1 2
DATA=1:RESET CAUSE
1=090B09DF 04/09/10 21:40:55
3=0644058B 04/09/10 22:13:19
5=09440AE4 04/09/11 09:07:23
7=0644058B 04/09/11 09:11:43
3 4 5
DATA=2:CONTROL PACKET COUNTER (PROTOCOL=2)
1=00000362 2=00000362
5=00000365 6=00000350
3 7
DATA=3:REGISTRATION NG
1=FF-DRS0 2=FF-DRS0
5=FF-DRS1 6=FF-DRS1
3 8
TIME OUT
9
Properties, and set emulation to VT100.
2=090B09DF 04/09/10 21:42:43
4=09440AE4 04/09/11 08:59:05
6=07440A12 04/09/11 09:07:48
8=0644058B 04/09/11 09:45:29
3 4 5
6
3=00000011 4=00000002
7=00000001
3=FF-DRS0 4=FF-DRS1
7=FF-DRS2 8=FF-DRS2
CHAPTER 1 MAINTENANCE SERVICE FEATURES
– 89 –
VoIP LOG COLLECTION
NWA-008847-001 Rev.3.0
a6ch1001.fm
JULY/01/2006