NEC NEAX 2000 IPS Maintenance Manual page 120

(4) Even if a LAN port on the MP card is being used for MAT/OAI or any other terminals, you can
execute the ping command.
(5) The following key operations are effective when the reply message resulting by executing the ping
command is displayed.
• DE (space key): To send again a ping request to the same IP address as the last one.
• - (hyphen key) : To send a ping request to the IP address with 1 subtracted from the last one.
Example: The ping request is sent to "192.168.1.2" if you press DE (space key) after sending it
to "192.168.1.3".
• S (return key) : To send a ping request to the IP address with 1 added to the last one.
Example: The ping request is sent to "192.168.1.3" if you press S (return key) after sending it to
"192.168.1.2".
NOTE: A LAN port on the MP card becomes occupied if you execute a ping command while DE (space
key) is pressed.
(6) The reply message resulting by executing the ping command is directly displayed in ICMP TYPE.
And "OK"/ "ERROR" displayed in MOC mode is not displayed. The reply message is as follows.
Example 1 <The reply message resulting by executing the ping command>:
COMMAND=FA20
FA20>00192168001002
192168001002: 0
Example 2 <The reply message resulting by executing the ping command>:
COMMAND=FA20
FA20>00192168001002
192168001002: 3
CHAPTER 1 MAINTENANCE SERVICE FEATURES
To send a ping request (ICMP TYPE=8) to "192.168.1.2"
ping OK (ICMP TYPE=0 Reply)
To send a ping request (ICMP TYPE=8) to "192.168.1.2"
ping NG (ICMP TYPE=3 Host unreachable)
– 110 –
PING COMMAND
NWA-008847-001 Rev.3.0
a6ch1001.fm
OCTOBER/14/2005