NEC NEAX 2000 IPS Maintenance Manual page 84

(3) To set a time to execute the changeover (changeback) of the MP program, do the following
programming.
START
CM0C For each Site, execute the changeover (change-
back) of MP program.
NOTE1:
NOTE2:
NOTE3:
NOTE4:
NOTE5:
NOTE6:
NOTE7:
END
DESCRIPTION
For MP program changeover, the system is reset automatically. Be sure not to set the time
while the system is operating.
If a specified changeover time is passed while MP program is being downloaded, the
changeover of MP program is executed immediately (second data becomes
000000000000).
If you set the second data to 000000000000 while MP program is being downloaded, the
MP program changeover is executed after MP program download is completed.
If you set the second data to 000000000000 while matching the program version of Flash
ROMs, the MP program changeover is executed after the program version matching is
completed.
This data is cleared after MP program changeover is completed.
If the system is reset five times during about three minutes, the MP program changeback
is executed automatically.
When the communication between Main Site and Remote Site cannot operate normally,
"HARDWARE ERROR" is displayed.
CHAPTER 1 MAINTENANCE SERVICE FEATURES
• Y=52
(1) XX01: Start time for changeover (change-
back)
XX : 00: Main Site No.
01-30: Remote Site No.
(2) YYYY MM DD HH mm:
Changeover (changeback) time
YYYY : 2000-2099 (Year)
MM
DD
HH
mm
000000000000: Now executing
CCC
NONE : No data
– 74 –
MP PROGRAM DOWNLOAD (FTP)
DATA
: 01-12 (Month)
: 01-31 (Date)
: 00-23 (Hour)
: 00-59 (Minute)
: Clear
NWA-008847-001 Rev.3.0
a6ch1001.fm
JULY/01/2006