NEC NEAX 2000 IPS Maintenance Manual page 111

(4) To provide releasing the path by RTP monitoring, do the following programming.
[Series 3700 R12.2 software required]
START
CM08 Provide releasing the path by RTP monitoring
via SIP card.
NOTE:
END
(5) To provide registering fault information (fault kind 43) by RTP monitoring, do the following
programming.
[Series 3700 R12.2 software required]
START
CM08 Provide registering fault information (fault
kind 43) by RTP monitoring via SIP card.
NOTE1:
NOTE2:
END
DESCRIPTION
When the second data of CM08>672 is set to 0, the path is released when the SIP card does
not receive RTP for 10 seconds after establishing the path.
DESCRIPTION
This command is effective when the fault information (fault kind 43) is assigned by CMEA
Y=2.
When the second data of CM08>679 is set to 1, the registering fault information (fault kind
43) by RTP monitoring via SIP card is performed as follows.
- When releasing the path by RTP monitoring via SIP card is provided (CM08>672: 0),
the fault information (fault kind 43) is registered whenever the path is released by RTP
monitoring.
- When releasing the path by RTP monitoring via SIP card is not provided (CM08>672:
1), the fault information (fault kind 43) is registered only one time.
CHAPTER 1 MAINTENANCE SERVICE FEATURES
(1) 672
(2) 0 : To provide
1 : Not provided
(1) 679
(2) 0 : Not provided
1 : To provide
– 101 –
VoIP LOG COLLECTION
DATA
DATA
NWA-008847-001 Rev.3.0
a6ch1001.fm
JULY/01/2006