Suzuki VZR1800 2007 Service Manual page 581

14-20 VZR1800 ('08-MODEL)
6) Disconnect the ECM coupler. (5-37)
7) Check the continuity between W/G or W/Bl wire A and termi-
nal B, E.
8) Also, check the continuity between B/Br wire B and terminal
S.

When using the multi-circuit tester, do not strongly
touch the terminal of the ECM coupler with a needle
pointed tester probe to prevent terminal damage or
terminal bend.
 O2S lead wire continuity: Continuity ()
 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
 Tester knob indication: Continuity test ()
Is the continuity OK?
YES Go to Step 2. (When indicating C44/P0130:)
W/G or W/Bl wire shorted to ground, or W/G and
NO
W/Bl or B/Br wire open.
9) After repairing the trouble, clear the DTC using SDS tool.
(5-26)
Step 2
1) Connect the ECM coupler and O2 sensor coupler.
2) Warm up the engine enough.
3) Measure the O2 sensor output voltage between W/G or W/Bl
wire and B/Br wire, when idling condition.
 O2 sensor output voltage at idle speed:
0.4 V and less (+ W/G or W/Bl – - B/Br)
4) If OK, then pinch the PAIR hose 1 with a proper hose clamp.
5) Remove the fuel tank (6-3) and frame head covers
(9-6).
6) Measure the O2 sensor output voltage while holding the
engine speed at 3 000 r/min.
 O2 sensor output voltage at 3 000 r/min:
0.6 V and more (+ W/G or W/Bl – - B/Br)
 09900-25008: Multi-circuit tester set
09900-25009: Needle pointed probe set
 Tester knob indication: Voltage ()
1
(Black)
ECM coupler (Harness side)
2
2
#1
(Gray)
V
#2