Suzuki VZR1800 2007 Service Manual page 183

4-12 DRIVELINE/AXLE
• If tooth contact is found to be incorrect, the shims of the sec-
ondary drive bevel gear and secondary driven bevel gear
must be changed, tooth contact should be re-checked until
correct.
$
After the tooth contact adjustment is made, the back-
lash must be re-checked, as it may change. Refer to
the backlash checking sub-section, and readjust until
both backlash and tooth contact are correct.
Tooth contact
Contact at tooth top 1
Contact at tooth root 3
SHIM SPECIFICATIONS
Drive bevel gear side
Part number
24935-48G00-040
24935-48G00-045
24935-48G00-050
24935-48G00-055
24935-48G00-060
24935-48G00-065
24935-48G00-070
24935-48G00-075
24935-48G00-080
NOTE:
The shims (drive bevel gear side) are available as a set
(24935-48810).
Driven bevel gear side
Part number
24945-26D00-030
24945-26D00-035
24945-26D00-040
24945-26D00-050
24945-26D00-060
NOTE:
The shims (driven bevel gear side) are available as a set
(24945-26810).
Shim adjustment
Decrease thickness of shims
4 or 5
Increase thickness of shims
4 or 5
Thickness
0.40 mm (0.016 in)
0.45 mm (0.018 in)
0.50 mm (0.020 in)
0.55 mm (0.022 in)
0.60 mm (0.024 in)
0.65 mm (0.026 in)
0.70 mm (0.028 in)
0.75 mm (0.030 in)
0.80 mm (0.031 in)
Shim thickness
0.30 mm (0.012 in)
0.35 mm (0.014 in)
0.40 mm (0.016 in)
0.50 mm (0.020 in)
0.60 mm (0.024 in)
!
INCORRECT (Contact at tooth root)