Suzuki VZR1800 2007 Service Manual page 330

• Check the EXCVA to adjustment position. (!7-2)
#
Do not use the adjustable wrench to turn EXCVA pul-
ley so as not to cause damage to the internal gear of
EXCVA.
• Install the pulley 8 to the shaft 9.
NOTE:
Make sure that the shaft's line D and cable slots E facing
upward as shown.
• Hold the EXCVA pulley with an adjustable wrench, and then
tighten the pulley mounting bolt to the specified torque.
$ EXCVA pulley mounting bolt: 5 N·m (0.5 kgf-m, 3.5 lb-ft)
#
When loosening or tightening the pulley bolt, be sure
to fix the pulley with an adjustable wrench, or EXCVA
may get damaged.
• After connecting the No. 2 cable 0, loosen the lock nut A
and turn the adjuster B in or out until 8.5 – 9.5 mm (0.33 –
0.37 in) of the thread length F on the cable adjuster cam be
provided and tighten the lock nut A.
#
The cable slots of the EXCVA pulley must be located
backward (adjustment position). (!7-2)
NOTE:
Install the rubber cover C correctly after inspecting it.
EXHAUST SYSTEM 7-5