Outputs; Audio - Datavideo HS-1300 Instruction Manual

Outputs

This sub menu allows the user to configure various output settings such as video output, audio output, and
GPI Out.
Advanced Mode
Outputs
Basic Mode
Outputs
Outputs
In general, the two SDI output ports (SDI 1 and SDI 2) located on the rear panel as well as the 17.3" built-in
monitor (HDMI) can be configured to output one of the following:
Note that Inputs 1 – 4 correspond to SDI 1 – 4 input ports. Inputs 5 and 6 are HDMI 1 and 2 input ports
respectively.
 Input 6 (HDMI 2 input port)
 Input 5 (HDMI 1 input port)
 Input 4 (SDI 4 input port)
 Input 3 (SDI 3 input port)
 Input 2 (SDI 2 input port)
 Input 1 (SDI 1 input port)
 CLN PVW (Clean PVW)
 CLN PGM (Clean PGM)
 PG + DSK
 PVW
 PGM
 MultiV (Multi view)
In addition to selecting your output source, you are also allowed to set two different resolutions for the
17.3" built-in monitor. The two available resolutions are 1080i and 1080p.

Audio

The Audio option for the SDI and HDMI outputs allows the user to individually turn ON/OFF the embedded
audio component for the 17.3" built-in monitor (HDMI) and at the SDI1 and SDI2 output ports (Sdi1 / Sdi
2).
Mode (On/Off): The HS-1300 can only accept external audio using the analogue XLR inputs on the rear
panel. Ideally a master audio mixer would be used alongside the HS-1300. A Datavideo AM-100 or AD-200
could be considered. By changing the Audio option from ON to OFF will mute the incoming XLR audio from
the external master audio mixer.
Output Sdi 1
Audio Mode
Sdi 1
Tally Mode Audio Mixer
GPI Out
MultiViewer AutoNum
Output Sdi 1
Audio Mode
Sdi 1
Pgm Sdi 2
On Src
On Sdi 2
Off Mode
Input 1 Delay
Off Label Inf
Pgm Sdi 2
On Src
On Sdi 2
39
Input 2 HDMI
Follow
On HDMI
Pulse Width
0
Off Trns Lab
Input 2 HDMI
Follow
On HDMI
1080P
On
1
Off
1080P
On