Table of Contents
Advertisement
Position
Position allows the user to adjust the centre position of some wipes (e.g Circle & Elipse). X represents the
horizontal position and Y represents the vertical position.
X
Positive value: position the wipe centre to the right
Negative value: position the wipe centre to the left
Zero value: Position the wipe centre at the screen
centre
Matte
The user can configure the Matte Luma, Saturation and Hue in this option.
IP Address
The displayed IP address allows the user to connect to the switcher from a remote location where network
connection is available.
Keyer
In this sub menu, the user is able to configure four keyers, which are Key 1, Key 2, DSK 1 and DSK 2.
Advanced Mode = Basic Mode
Keyer
Keyer Control
There are three keying modes available: Linear, Luma, and Chroma.
After the keying mode is chosen, if only one source (Luma or Chroma) is required for the keyer, select Self
then the source in Key Source. If two sources (DSK) are required for the keyer, select Split then the
respective sources in Key and Fill Sources. You may also select P-in-P or P-in-P Lite to apply the keying
effect to the PIP window.
Please note:
If Luma is selected, fine tune the Luma Keyer parameters (Lift, Gain and Opac) in the Keyer option.
If Chroma is selected, fine tune the Chroma Keyer parameters in the Chroma sub menu.
If P-in-P is selected, fine tune its parameters in the P-in-P sub menu.
If P-in-P Lite is selected, fine tune its parameters in the P-in-P Lite sub menu.
For example, if the user selects Key 1 Chroma P-in-P, he is performing chromakeying of the P-in-P
image after the relevant chroma keyer parameters are adjusted in the Chroma sub menu.
Priority sets the key image to either the top layer or bottom layer and is functional only if Key 1 and Key 2
are enabled at the same time.
Keyer
Keyer Ctrl
Chroma
Lift
Key Source
Mask
Left
Top
Y
Positive value: move the wipe centre up
Negative value: move the wipe centre down
Zero value: Position the wipe centre at the
screen centre
Key 1
0% Gain
Input 1
Fill
0% Right
0% Bot
33
P-in-P
Priority
1.0 Opac
Input 3
0%
0%
Bot
100%
Advertisement
Table of Contents
Troubleshooting
