Operation Mode - Datavideo HS-1300 Instruction Manual

Note: The system will return to the original setting if the BITRATE button is not pressed. The default
bitrate is M.

Operation Mode

Checking the NVS-31's operation mode
Follow the steps below to check the NVS-31's current operation mode:
 First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD buttons
are solid white.
 Press RECORD or STREAM button.
 The button LED should behave according to the device's operation mode. The LED behaviors are
summarized in the table below:
Solid red STREAM button
Solid white STREAM button
 The two buttons turn solid white a few seconds after displaying the operation mode.
Switching operation modes
Follow the steps below to switch to the next operation mode:
 First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD buttons
are solid white.
 Simultaneously press and hold the RECORD and STREAM buttons for more than 3 seconds but less
than 10 seconds.
 As the operation mode switches, both the RECORD and STREAM buttons turn from solid red, then
blinking red and finally to solid white.
 When the RECORD and STREAM buttons turn solid white, it indicates that the NVS-31 has been
switched to the next operation mode successfully.
Note: The order of the operation mode change is Stream & Record  Stream Only  Record Only
Checking the next operation mode
Follow the steps below to check the operation mode next to the NVS-31's current operation mode before
switching:
 First make sure the stream and record functions are in idle state, i.e. STREAM and RECORD buttons
are solid white.
 Simultaneously press and hold the RECORD and STREAM buttons for more than 1 second but less
than 3 seconds.
 The button LED should behave according to the device's next operation mode. The LED behaviors
are summarized in the table below:
Solid red STREAM button
Solid white STREAM button
 The two buttons turn solid white a few seconds after displaying the operation mode.
Solid red RECORD button
Stream & Record
Record Only Mode
Solid red RECORD button
Stream & Record
Record Only Mode
80
Solid white RECORD button
Stream Only Mode
None
Solid white RECORD button
Stream Only Mode
None