Table of Contents
Advertisement
MAIN Video Outputs
The HS-600 has a number of video outputs. The video outputs labelled MAIN are two Composite (CV) BNC
connectors on the HS-600 rear panel.
These outputs should remain set in the menu as two Composite (CV) outputs and a single Y/C output.
The Y/C connection is not present externally as it is used internally to feed the built in monitor panel with Program
output. If the monitor panel program output stops working use the menus below to ensure it is correctly set.
1: COUNT_DOWN_TIME
2: PIP
3: CG (LUMA KEY)
4: LOGO
5: VIDEO IN & OUT
6: AUDIO MIXER
7: MULTI. IMAGE
8: SYSTEM
9: STORE RECALL & UPDATE
10: RESET DVI_IN
ESCAPE
[ IN / OUT SELECT ]
1: INPUT
2: OUTPUT
3: ASSIGN VIDEO SOURCES
4: DV & SDI
ESCAPE
[ VIDEO OUTPUT SETTING ]
1: OUTPUT MODE = CV*2
2: ASPECT RATIO = 4 : 3
3: V_OUT 7.5 IRE = OFF (NTSC_ONLY)
ESCAPE
The HS-600 is set up by a series of menus. Once the initial settings
have been chosen they are stored within the system, so it may only be
necessary to make these changes once.
When the SETTING button is pressed in the EFFECTS area of the
HS-600 keyboard the Main Menu list, shown left, is displayed between
the PST and PGM images on the Multi-Image Preview output.
This menu option allows the user to change settings which effect video
coming into or going out of the HS-600. Use the arrow buttons to
highlight the VIDEO IN & OUT item then press the ENTER button to
confirm the selection.
This text confirms if the mixer is a PAL or NTSC unit.
(PAL )
Use the up or down arrows to select the required outputs shown.
Aspect Ratio can be set to 16:9 or 4:3 depending on your inputs.
Used on NTSC models only – IRE (black level) can be 0 or 7.5.
29
Advertisement
Table of Contents
