Opc Ua Error Messages - Siemens SIMATIC RF600 Series Configuration Manual

"ER" XML/ PLC block
LED LED (hex)
(hex)
-- 0x97 0xE7FE09
-- 0x7A 0xE7FE0A
"--" means that the error is not displayed by the LEDs.
13.2.3

OPC UA error messages

The following table lists the OPC UA-specific error codes.
Table 13- 3 OPC UA error messages of the RF600 readers
AutoId XML/ OPC UA
status LED status
(hex)
1 0xCA good
1 0xCD good
1 0xE6 good
1 0xEA good
1 0xEB good
3 0x1A good
4 0x92 good
SIMATIC RF600
Configuration Manual, 11/2018, C79000-G8976-C386-07
Error description
Command repetition is not supported.
Error during the transfer of the PDU (Protocol Data Unit).
AutoId
text
MISC_ERROR_
TOTAL
MISC_ERROR_
TOTAL
MISC_ERROR_
TOTAL
MISC_ERROR_
TOTAL
MISC_ERROR_
TOTAL
PERMISSON_
ERROR
PASSWORD_
ERROR
Error description
General error
Firmware error
•
Possible cause: The firmware update was not run
completely.
Internal communications error of the communications
•
module/reader
– Connector contact problem on the communica-
tions module/reader
– Hardware of the communications module / reader
has a defect; → Send in communications module /
reader for repair
– Start "INIT" after correcting the error
Internal monitoring error of the communications mod-
•
ule/reader
– Program execution error on the communications
module / reader
– Turn the power supply of the communications
module/reader off and on again
– Start "INIT" after correcting the error
The inventory command failed.
Enabling write protection on the transponder failed.
The "Kill" command failed.
The transponder is read/write-protected.
The transponder password is incorrect. Access is denied.
Service and maintenance
13.2 Error messages
253