Programming via Rockwell controller
9.6 Programming the Ident profile
9.6.2
Overview of the commands
The following table contains all the commands supported by the Ident profile and the
"AdvancedCMD" block.
Table 9- 19
Commands of the Ident profile
Command
Command code
HEX
PHYSICAL-READ
70
PHYSICAL-WRITE 71
READER-STATUS 74
INVENTORY
69
WRITE-ID
67
KILL-TAG
6A
LOCK-TAG-BANK
79
EDIT-BLACKLIST
7A
GET-BLACKLIST
6C
READ-CONFIG
61
WRITE-CONFIG
78
132
Parameters used
ASCII
'p'
OFFSETBUFFER,
EPCID_UID, LEN_ID,
LEN_DATA, ADDR_TAG,
MEM_BANK, PSWD
'q'
OFFSETBUFFER,
EPCID_UID, LEN_ID,
LEN_DATA, ADDR_TAG,
MEM_BANK, PSWD
't'
OFFSETBUFFER,
ATTRIBUTES
'i'
OFFSETBUFFER,
ATTRIBUTES, DURATION,
DUR_UNIT
'g'
OFFSETBUFFER,
EPCID_UID, LEN_ID,
LEN_ID_NEW, PSWD
'j'
EPCID_UID, LEN_ID,
PSWD
'y'
EPCID_UID, LEN_ID,
PSWD, ACTION, MASK
'z'
EPCID_UID, LEN_ID,
MODE
'l'
OFFSETBUFFER
'a'
--
'x'
LEN_DATA, CONFIG
Description
Reads data from a transponder by specifying
the physical start address of the memory bank
(UHF), the length and the password.
Writes data to a transponder by specifying the
physical start address of the memory bank
(UHF), the length and the password.
Reads out the status of the reader.
Requests a list of all currently accessible tran-
sponders within the antenna range.
RF680R/RF685R:
Writes a new EPC-ID to the transponder.
RF680R/RF685R:
The transponder is permanently deactivated.
RF680R/RF685R:
The corresponding memory area of the tran-
sponder is blocked as specified.
RF680R/RF685R:
The black list is processed. The current tran-
sponder can be added, all identified transpond-
ers added, individual transponders deleted or all
transponders deleted.
RF680R/RF685R:
The entire EPC-IDs are read out from the black
list.
Reads out the parameters from the reader.
Sends new parameters to the reader.
Configuration Manual, 11/2018, C79000-G8976-C386-07
SIMATIC RF600