Reading Out Error Messages Using The Wbm; Xml Error Messages; Opc Ua Error Messages - Siemens SIMATIC RF185C Operating Instructions Manual

12.2.2

Reading out error messages using the WBM

Reading out error messages using the WBM
All the diagnostics messages of the communication module are entered in the "Log" if a
check mark was set for "ERRORS" in the WBM configuration in "Settings - General". You will
find further information on the "Log" in the section "The "Diagnostics - Log" menu item
(Page 97)".
12.2.3

XML error messages

A list of the possible XML error codes can be found in the "XML programming for SIMATIC
Ident (https://support.industry.siemens.com/cs/ww/en/ps/14971/man)" manual.
12.2.4

OPC UA error messages

The following table lists the OPC UA-specific error codes.
Table 12- 6 OPC UA error messages of the communication module
AutoId OPC UA
status status
1 good
1 good
1 good
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 04/2020, C79000-G8976-C512-03
AutoId
text
MISC_ERROR_
TOTAL
MISC_ERROR_
TOTAL
MISC_ERROR_
TOTAL
Error description
General error
Firmware error
•
Possible cause: The firmware update was not run complete-
ly.
Internal communication error of the communication mod-
•
ule/reader
– Connector contact problem on the communication mod-
ule / reader
– Hardware of the communication module/reader has a
defect; → Send in communication module/reader for re-
pair
– Start "INIT" after correcting the error
Internal monitoring error of the communication mod-
•
ule/reader
– Program execution error on the communication module /
reader
– Turn the power supply of the communication mod-
ule/reader off and on again
– Start "INIT" after correcting the error
The inventory command failed.
Service and maintenance
12.2 Error messages
163