Killtag - Siemens SIMATIC RF600 Series Configuration Manual

Programming via XML interface
10.3 XML commands
10.3.3.11

killTag

With this command, the selected transponder is deactivated. If no EPC-ID is made available
or detected, the command is executed with all the transponders recognized from the read
point.
Note
If no EPC-ID is specified, the results are influenced by all the set filter mechanisms (refer to
the section "The "Settings - Filters" menu item (Page 66)"). Then in the reply frame, only the
transponders that were not filtered out appear. If an EPC-ID is specified, the data filter has
no effect.
The reply frame contains the IDs of all identified transponders. A flag for each transponder
indicates whether or not the command was successful for this transponder.
If no transponder was identified, a negative reply is returned.
Command
<frame>
<cmd>
</cmd>
</frame>
// opt → Optional: Line can be omitted.
Reply
<frame>
<reply>
204
<id> value_id </id>
<killTag>
<sourceName> value_sourceName </sourceName>
<tagID> value_tagID </tagID>
<password> value_password </password>
</killTag>
<id> value_id </id>
<resultCode> 0 </resultCode>
<killTag>
<returnValue>
<tag>
<tagID> value_tagID </tagID>
<tagPC> value_tagPC </tagPC>
<success> value_success </success>
<utcTime> value_utcTime </utcTime>
<antennaName> value_antennaName </antennaName>
<rSSI> value_rSSI </rSSI>
<channel> value_channel </channel>
// opt
// opt
// opt
Configuration Manual, 11/2018, C79000-G8976-C386-07
// opt
// opt
// opt
SIMATIC RF600