Sennheiser SpeechLine Digital Wireless Series System Documentation page 81

Variant 1
Single Cable Mode (default)
PoE /
network control
daisy chain digital audio
Connecting the receiver
The receiver can output analog and digital audio signals.
The analog audio signal is output via the 3-pin Analog Out terminal.
Digital audio signals are output via the Dante interface with two RJ-45
sockets. This interface is also used for control and configuration via the
network and for Power over Ethernet supply.
The following variants are possible:
►
Variant 2
Audio Redundancy Mode
PoE /
network control
digital audio digital audio
To configure the variants you need the Audinate Dante Controller
software: www.audinate.com
SL MCR DW
Variant 3
Split Mode
PoE /
digital audio network control
80