•
If possible, position the receiver so that there is always a direct line of
sight between the antennas (directly on the receiver or remotely mount-
ed) and the paired transmitter.
•
If possible, remove obstacles between the transmitter and the anten-
nas.
•
Pay attention to the notes about antenna installation: „Recommenda-
tions on antenna mounting"
•
If necessary, adjust the manually selected transmission power in the
Control Cockpit under RF power mode on the RF settings tab. You can
find more information under „Multi-room mode".
Performing a walk test with the SL Rack Receiver DW on the device
To perform a walk test on the device:
▷
Switch on the transmitter and the receiver of the radio link you want to
check.
▷
In addition, switch on all other devices that you want to use in the op-
erating environment.
▷
From the receiver's System Settings menu, select the Walk Test
menu item.
The RF signal level display appears on the display panel of both the re-
ceiver and the transmitter.
►
Walk the operating environment with the transmitter.
▷
The RF signal level display on the display panel of both the receiver and
the transmitter is continuously updated.
▷
Check the RF signal level display for more detailed information on the
reception quality:
Good reception quality is indicated by a tick.
If the tick is missing, reception quality is sufficient.
If reception quality is or was compromised at any position, this is
indicated by a warning triangle.
The warning triangle remains displayed on the display panel even if
reception quality improves afterwards.
Performing a walk test (reception quality)
142