Table of Contents
Advertisement
Installing receivers in a rack
This chapter describes how to install a single receiver or two receivers side
by side in a rack.
You can also set up the receiver without installing it in a fixed location. You
can find more information about setting up the receiver under: „Setting up
the receiver".
ATTENTION
Danger due to high temperature, mechanical loading or electric leak-
age currents
When rack mounted, a receiver can be damaged by excessive heat or me-
chanical stress.
Make sure that the temperature within the rack does not exceed the
▷
permissible temperature limit specified in the specifications.
Make sure that the receivers in the rack are not subject to mechanical
▷
stress.
Make sure that circuits are not overloaded by providing overcurrent
▷
protection if necessary.
▷
Make sure that the sum of the leakage currents of all power supply
units do not exceed the allowable limit values by grounding the rack via
an additional ground connection, if necessary.
SL Rack Receiver DW
64
Advertisement
Table of Contents
