Table of Contents
Advertisement
Fastening the mounting angles (to install an antenna splitter)
To fasten the mounting angles:
Remove the two recessed head screws on each side of the antenna
▷
splitter.
▷
Fasten the mounting angles to the sides of the antenna splitter by tight-
ening the previously removed recessed head screws.
Make sure that the angled ends of the mounting angles point forward.
►
Installing the antenna splitter in a rack
To install the antenna splitter in a rack:
▷
Screw the front panel from the GA 4 mounting kit onto the antenna
splitter's mounting angle using the two included recessed head screws
as shown in the figure.
Make sure to use the correct side (the one with the round holes) of the
blanking plate to secure it to the mounting angle.
►
▷
Insert the two small blanking plugs into the unused antenna holes.
Screw the unit consisting of antenna splitter and mounting accessories
▷
into a 19" rack.
The SL PASC 4 passive antenna splitter/combiner
186
Advertisement
Table of Contents
