Suzuki TU250X Service Manual page 63

3-16 ENGINE
STARTER IDLE GEAR
• Remove the starter idle gear shaft 1 and starter idle gear 2.
CLUTCH COVER
• Remove the clutch cover 1.
• Remove the dowel pins and gasket 2.
CLUTCH
• Remove the clutch spring set bolts, clutch springs and clutch
pressure plate 1.
NOTE:
Loosen the clutch spring set bolts little by little and diagonally.
• Remove the washer 2, release bearing 3, push piece 4.
• Remove the push rod 5.
NOTE:
If it is difficult to pull out the push rod 5, use a magnetic hand or
a wire.