Suzuki TU250X Service Manual page 261

BRAKE CAM
Inspect the brake cam for abnormal wear.
Place the brake cam into the brake panel and check for smooth
rotation.
Check that the rotating parts are coated with sufficient grease.
BRAKE PANEL
Inspect the brake panel for wear or damage. If any defects are
found, replace the brake panel with a new one.
REASSEMBLY AND INSTALLATION
Reassemble and install the rear brake in the reverse order of
removal and disassembly. Pay attention to the following points:
• Apply grease to the camshaft, cam face and pin.
 99000-25010: SUZUKI SUPER GREASE "A"
• Install the brake shoes with spring hooks 1 faced inside.

Be careful not to apply too much grease to the cam
and pin. If grease gets on the lining, brake slippage
will result.
• When installing the brake cam lever, align the line A of brake
cam with slit B of brake cam lever.
• Tighten the brake cam lever nut to the specified torque.
 Rear brake cam lever nut: 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
• Install the rear wheel. (8-52)
or equivalent
CHASSIS 8-41