Operation Mode; Relay Configuration; Jumper Settings; The Relays’ Hardware Jumpers - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.6.2

Operation Mode

7.3.6.3

Relay Configuration

7.3.6.3.1
Figure 7-8
Part No.: 4417340 Revision 1
In addition to the board's
available (see Figure
the [LED Association]
☛
For a fail-safe level application, continue with section
The FII-DO can operate in one of two modes:
[Fallback Mode]. This is controlled by the
Fallback Mode is not implemented yet.
☛
Set the [Operation Mode] entity to [Alarm Mode].

Jumper Settings

At installation, each individual relay contact was configured as required
with the hardware jumpers JPx0, where x = Relay 1 to 4 respectively.
See Figure 7-8.
The relays' hardware jumpers
NOTE: In the Commissioning stage, no jumper setting can be changed
without breaking the compartment screw sealing.
Service Manual
954 SmartServo FlexLine
[Health] LED LE1, the LEDs LE2 and LE3 are
7-7). They can be associated to a relay, by setting
entity.
[Operation Mode]
7.3.6.10.
[Alarm Mode] and
entity.
99