COMMISSIONING
7.3.6.4.5
7.3.6.5
Commands
7.3.6.5.1
7.3.6.5.2
104
Not in Use
If an individual relay is not required in a particular application, the
Mode]
entity must be set to
Example: If a particular application requires only two relays to be used,
say relay 1 and 2, then for relay 3 and 4 the
be set to
<Not In Use>.
☛
For the FII-DO relays not used within the application, set the
Mode]
entities to
<Not In Use>.
The following commands can be given to the FII-DO:
Activate
Deactivate
Acknowledge
Activate
The
!Activate!
command will cause the specified relay to become
<Activated>. This command is only available in
see
7.3.6.4.4.
The
!Activate!
command behavior is modified by the
entity. If the
[Time Setting]
permanently activated until a
If the
[Time Setting]
entity is set to a value other than zero, the relay will
be activated for a time in seconds equal to the value set in the
Setting]
entity, then deactivated. During the period the relay is activated,
the relay state will be
commissioning.
☛
For each relay, set the
Deactivate
The
!Deactivate!
command will cause the specified relay to become
<Deactivated>.
This command is only available in
mode; see
7.3.6.4.4.
Service Manual
954 SmartServo FlexLine
<Not In Use>.
entity is set to zero, the relay will stay
!Deactivate!
command is given.
!Time Setting Active!.
[Time Setting]
[Alarm Mode]
entities must
[Remote Control]
[Time Setting]
[Time
This is useful for site
entity to the desired value.
[Remote Control]
Part No.: 4417340 Revision 1
[Alarm
[Alarm
mode;