Entering search mode from hygiene mode
In order to change the instrument's operational mode from Hygiene Mode to Search Mode, you
must enter the password-protected Programming Mode:
1. Hold [MODE] and [N/-] until you see the password screen.
2. Use [Y/+] to increment to the number you want for the first digit. (If you pass by the desired
number, press [Y/+] until it cycles through to 0 again. Then press [Y/+] until you reach the
desired number.)
3. Press [N/-] to advance to the next digit.
4. Again press [Y/+] to increment the number.
5. Press [N/-] to advance to the next digit.
Continue the process until all four numbers of the password have been input. Then press
[MODE] to proceed.
The screen changes to icons with the label "Calibration."
1. Press [N/-] to advance to "Monitor Setup."
2. Press [Y/+] to select Monitor Setup.
Under Monitor Setup, you will see "Op Mode."
3. Press [Y/+] to select.
You will see:
Hygiene
Search
The current mode is indicated by a dark circle within the circle in front of either Hygiene or
Search.
1. Select Hygiene or Search by pressing [N/-].
2. Press [Y/+] to place the instrument into the selected mode.
3. Press [MODE] when you want to register your selection to place the instrument in the
selected mode.
4. Press [Y/+] to commit the change and exit to the Monitor Setup screen, or press [N/-] to
Undo (exit to the Monitor Setup screen without changing the Mode).
Handheld PID Monitors
Rolling Graph: Gives you a visual guidance to seek a source. Use the Safety Suite
Device Configurator (SSDC) Software to enable this feature.
94
User Manual