Commissioning Parameters For All Types Of Probes - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.8.4.4
Name
[Product immersion depth]
[Hysteresis]
[High high alarm]
[High alarm]
[Low alarm]
[Low low alarm]
[Alarm test enable]
[Alarm test]
[Function identification]
[Element offset]
Part No.: 4417340 Revision 1

Commissioning Parameters for All Types of Probes

Engauge *Product temperature* Tab
☛
The following entities can be set set by Engauge or HART
SmartView for a specific functioning of the FII-RTD module in an
instrument. The default values are available after initialization of the
non-volatile memory; so check each entity for its correctness.
Explanation
The minimum required
product level distance
above an element before
this element is taken into
account in the average
product temperature
calculation
This is a hysteresis
mechanism distance
around the switching points
of the elements that are
taken into account in the
calculation.
4 thresholds for activating a
related alarm status in the
Primary Value
Enables (if activated, see
next listed entity) the
simulation of one of the 4
alarms for a minute, by
simulating the actual
measured Primary Value is
slightly below or above the
alarm threshold.
Activates and selects at the
same time the Alarm test (if
enabled with the
enable]
listed before, and the
4 alarm thresholds are
properly set).
The current module's
function name. This
function is visible on the
HART SmartView
di l
Each element can
individually be given an
offset.
Service Manual
954 SmartServo FlexLine
Value Range
floating point number:
<-x.x .. +x.x>
floating point number:
<-x.x .. +x.x>
floating point numbers:
<-x.x .. +x.x>
<Enable>
<Disable>
<No Alarm>
<High-high alarm>
<High alarm>
[Alarm test
<Low alarm>
<Low-low alarm>
13 characters
floating point numbers:
<-x.x .. +x.x>
Default
<0.5>
<0.1>
<1.0E22>
<disable>
<No Alarm>
<Product temp.>
<0.0>
143