Alarm Mode; Pv Monitor; Monitor Mode - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
7.3.6.4

Alarm Mode

7.3.6.4.1
7.3.6.4.2
Part No.: 4417340 Revision 1
Each individual relay can operate in one out of three modes, by setting
the [Alarm Mode] entity to either
In Use].

PV Monitor

In [PV Monitor] mode, each individual FII-DO-relay unit can monitor the
Primary Value (PV) or Secondary Value (SV) of another board
connected to the CAN bus, and either activate or deactivate the
associated relay if a certain condition is
☛
If [Remote Control]
section 7.3.6.4.4 and 0 respectively.
☛
From the [Alarm Mode]
☛
Select [Monitor Board ID],
☛
Select [Monitor Board Instance],
☛
Select [Monitor Function Instance], set proper value.
☛
Select [Monitor Source],
The [Monitor Board ID], [Monitor Board Instance], and [Monitor Function
Instance] entities determine the location of the entity to be scanned.
The behavior of each individual relay in PV Monitor mode is further
controlled by the

[Monitor Mode]

next.
Monitor Mode
The [Monitor Mode] entity can either be set to
If the [Monitor Mode]

the scanned PV or SV is monitored. The alarm status is
compared against the value set in the
Source] entity. The
be set to
Example: If the [Remote Threshold Source]
High Alarm occurs, the relay will be activated. It will not be activated by
any other alarms.
Service Manual
954 SmartServo FlexLine
[PV Monitor], [Remote Control],
<True>
or [Not In Use] mode must be selected, skip to
menu, select [PV
set proper value.
set proper value.
select either <PV>
and the [Status Behavior]
is set to
[Remote Threshold Source]
<HH>, <HA>, <LA>, or <LL>.
or <False>.
Monitor].
or <SV>, as desired.
entities; see
[Remote] or [Local].
[Remote], the alarm status of
[Remote Threshold
entity can
is set to <HH> and a High
or [Not
101