Hart Universal Ccommands; Hart Common Practice Commands - Honeywell FlexLine SmartServo 954 Service Manual

COMMISSIONING
150
All the HART universal commands and some common practice
commands are supported by HCI-HAO. These are listed in the below
tables.
Command no.
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22

HART Common Practice Commands

Command no.
34
35
36
37
38
40
41
42
44
48
53
72
Service Manual
954 SmartServo FlexLine

HART Universal Ccommands

Description
Read Unique Identifier
Read Primary Variable
Read Loop Current and Percentage of Range
Read Dynamic variables and Loop Current
Reserved
Reserved
Write Polling Address
Read Loop Configuration
Read Dynamic Variable Classifications
Read Device Variable With Status
Reserved
Read Unique Identifier Associated with Tag
Read Message
Read Tag, Descriptor, Date
Read PV Sensor Information
Read Device Information
Read Final Assembly Number
Write Message
Write Tag, Descriptor, Date
Write Final Assembly Number
Read Long Tag
Read Unique Identifier Associated With Long Tag
Write Long Tag
Description
Write Primary Variable Damping Value
Write Primary Variable Range Values
Set Primary Variable Upper Range Value
Set Primary Variable Lower Range Value
Reset Configuration Changed Flags
Enter / Exit Fixed Current Mode
Perform Self Test
Perform Device Reset
Write Primary Variable Units
Read Additional Device Status
Write Device Variable Units
Squawk
Part No.: 4417340 Revision 1