Assembly 4.1 Battery; To Assemble The Steering Wheel; To Adjust Height Of The Steering Wheel; To Assemble The Seat - Husqvarna R419TsX AWD Workshop Manual

4.1 Battery
Charge the battery at 12V, maximum 3A for 4 hours.
Use a Husqvarna battery charger. Refer to
tools on page 19 .

4.2 To assemble the steering wheel

1. Install the steering wheel with steering column tube
onto the steering column. Select applicable height.
2. Turn the knob clockwise to tighten.

4.3 To adjust height of the steering wheel

WARNING: Do not adjust the height of the
steering wheel during operation of the product.
1. Turn the knob counterclockwise to loosen.
2. Adjust the height of the steering wheel.
3. Turn the knob clockwise to tighten.
CAUTION: Make sure that the long end of the
knob points up.
10 - Assembly
4 Assembly

4.4 To assemble the seat

1. Attach the 4 screws.
Servicing
2. Install the operator presence control (OPC). Refer to
To remove and install the Operator presence control
(OPC) on page 43 .

4.5 To adjust the seat

1. To adjust the seat forward and rearward, put your
feet on the footrest plates.
2. Push the lever below the front edge of the seat, to
the side.
3. Move the seat to the position that is correct for you.
WARNING: Do not adjust the seat during
operation of the product.
914 - 003 - 28.03.2019