Husqvarna R419TsX AWD Workshop Manual page 48

9.5.8 To replace the oil in the front and rear
hydrostatic transmissions
WARNING: Transmission oil is dangerous to
your skin. Clean spills with soap and water.
WARNING: Used oil and filters are dangerous
to the environment. Discard used chemicals at
an applicable disposal location.
To keep the hydraulic system
Obey the instructions in
clean on page 46 .
1. Put a container below the drain plugs.
2. Open the 2 plugs to drain the front hydrostatic
transmission.
3. Open the 2 plugs to drain the rear hydrostatic
transmission.
4. Replace the hydrostatic transmission filter. See
replace the hydrostatic transmission filter on page
48 .
5. Attach the drain plugs.
6. Fill the transmission oil tank with oil.
7. Bleed the hydrostatic transmission. See
the drive system on page 50 .
8. Do a test of the product and fill with oil to the correct
level in the transmission oil tank.
48 - Repair instructions
9.5.9 To replace the hydrostatic transmission filter
This filter is behind the rear transmission and must be
changed when the oil is changed.
Obey the instructions in
clean on page 46 .
1. Drain the oil from the rear transmission. See
replace the oil in the front and rear hydrostatic
transmissions on page 48 .
2. Remove the filter lid and pull out the filter.
To
3. Push in the new filter until the rubber seal in the front
is in position.
4. Attach the filter lid.
Note: The filter is not in the correct position if the
spring must be compressed before the filter lid
To bleed thread connects.
9.5.10 To replace the hydraulic oil filter
1. Clean the area around the oil filter. Refer to
the hydraulic system clean on page 46 .
2. Turn the hydraulic oil filter counterclockwise to
remove it.
WARNING: Transmission oil is dangerous to
your skin. Clean spills with soap and water.
WARNING: Used oil and filters are dangerous
to the environment. Discard used chemicals at
an applicable disposal location.
CAUTION: Do not tighten the filter lid to much.
The filter lid is made of plastic.
To keep the hydraulic system
To
To keep
914 - 003 - 28.03.2019