Husqvarna R419TsX AWD Workshop Manual page 38

4. Put a M14X180 screw (E) in the PTO clutch to
loosen the belt pulley and PTO clutch from the
engine shaft. Hold the top of the belt pulley (D) with
a pipe wrench if it is necessary.
E
5. Lift the engine to remove the PTO clutch and the
belt pulley.
9.2.4 To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick back in and tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
38 - Repair instructions
D
8. Fill the oil through the hole that the dipstick sits in.
Fill the oil slowly.
Note: See Technical data on page 72 for the types
of engine oil that we recommend. Do not mix
different types of oil.
9. Tighten the dipstick correctly before you start the
engine. Start and idle the engine for approximately
30 seconds. Stop the engine. Wait 30 seconds and
do a check of the oil level again.
9.2.5 To replace the engine oil and oil filter
If the engine is cold, start the engine for 1–2 minutes
before you drain the engine oil. This makes the engine
oil warm and easier to drain.
WARNING: Do not operate the engine for more
than 1–2 minutes before you drain the engine
oil. The engine oil becomes very hot and can
cause burn injuries. Let the engine become cool
before you drain the engine oil.
WARNING: If you spill engine oil on your body,
clean with soap and water.
Note: The illustrations of the oil drain plug shows a
engine.
1. Put a container below the oil drain plug.
2. Open the plastic cap on the end of the oil drain plug.
3. Attach a plastic hose to the end of the oil drain plug
to prevent spill.
914 - 003 - 28.03.2019