13. Remove the 4 engine screws.
14. Lift the engine.
15. Install the engine in the opposite sequence.
Note: The belt pulley groove must align with the
output shaft key. Make sure that the spacer pipe (A)
and shaft key (B) are attached to the engine shaft.
Put grease on the engine shaft when you attach the
engine belt pulley.
914 - 003 - 28.03.2019
9.2.2 To remove and install the engine on
R420TsX AWD
1. Remove the engine cover. Refer to
install the engine cover on page 24
2. Disconnect the battery terminals (A), open the strap
(B) and remove the battery. Refer to
on page 4 .
A
B
To remove and
Risk of sparks
A
Repair instructions - 35
B