Husqvarna R419TsX AWD Workshop Manual page 18

3. TRANSMISSION, CONTROLS AND DRIVE SYSTEM
Do a check of/adjust front and rear wheel speed, AWD models only
Do a check of the oil in the transmission and fill if it is necessary. Refer to
cal data on page 72 .
Make sure that the tire pressure is correct. Refer to
Examine and adjust the parking brake.
Replace oil filter in the transmission.
Replace the spin-on filter of the servo.
Replace the oil in the transmission. Refer to
4. CUTTING EQUIPMENT
Clean the outer and inner surfaces of the cutting deck and the cutting deck cov-
ers.
Do a check of and adjust the cutting height.
Do a check of and adjust the parallelism of the cutting deck.
5. FINAL INSPECTION AND DOCUMENTATION
Do a check of and adjust the engine speed, rpm. Refer to
page 72 .
Make sure that the product do not move in neutral position.
Do a check of the forward drive and the rearward drive on different speeds.
Do a check of the blade engagement, seat, lift and forward drive/brake.
Do a check of the collecting system, when aplicable.
18 - Maintenance
Technical data on page 72 .
Technical data on page 72 .
Technical data on
First serv- Maintenance interval
ice in hours
50 100
O
Techni-
O
O
O
O
O
First serv- Maintenance interval
ice in hours
50 100
O
O
O
First serv- Maintenance interval
ice in hours
50 100
O
O
O
O
O
914 - 003 - 28.03.2019
200
O
O
O
O
O
O
O
200
O
O
O
200
O
O
O
O
O