Husqvarna R419TsX AWD Workshop Manual page 32

15. Remove the snap ring and washer from the inner
groove on the pivoting rear axle (B).
B
16. Pull out the pivoting rear axle from the rear. Use a
slide hammer or a puller if it is necessary.
17. Replace the dirt protection (A) if it is damaged.
9.1.5.2 To replace the bushings on the pivoting rear axle
CAUTION: When the pivoting rear axle is
removed, replace the bushings in the rear
frame.
1. Remove the bushings with a drift. Refer to
tools on page 19
2. Attach the new bushings with a drift. Make sure that
the grooves in the bushings run horizontally.
3. Align the outer edges of the bushings with the outer
edge of the hole.
4. Lubricate the bushings with a lithium based grease.
32 - Repair instructions
A
Servicing
9.1.5.3 To assemble the pivoting rear axle
1. Put the axle into the bushings.
Note: Make sure that the hole on the axle points
rearward.
2. Install the washer and snap ring on the front end of
the pivoting rear axle.
3. Install the dirt protection approximately ⅔ into the
axle.
4. Lubricate the axle on the 2 sides of the dirt
protection.
5. Move the rear frame forward and push it onto the
pivoting rear axle.
6. Install the washer and snap ring on the pivoting rear
axle.
7. Install the rear belt.
8. Install the hydrostatic transmission fan.
9. Install the hydrostatic transmission cable. Make sure
that the hydrostatic transmission is correctly
To adjust the hydrostatic
adjusted. Refer to
transmission cable on page 57 .
10. Install the brake cable on two-wheel drive products.
11. Install the idler spring.
12. Install the rear wheels.
13. Lower the product
14. Connect the hydraulic hoses to the couplings below
the product.
15. Fill and bleed the hydrostatic transmission system.
To bleed the drive system on page 50 .
Refer to
16. Install the transmission cover.
914 - 003 - 28.03.2019