Assembly; Operation - Husqvarna LB 448iV Operator's Manual

Introduction
WARNING:
product, read the safety chapter.
WARNING:
during assembly, remove the safety key,
remove the batteries and wait a minimum of
5 seconds.
To assemble the handle
1. Remove the handle nut and the washer from the
plate on the upper handle.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
Husqvarna Fleet Services
Husqvarna Fleet Services
gives the commercial fleet manager an overview
of all products. It is a requirement to have the
Husqvarna Fleet Services
product. The product is prepared for installation of
a Husqvarna Fleet Services
information about Husqvarna Fleet Services
www.husqvarna.com.
To prepare the sensor (accessory)
1. Use the sensor key to open the lid of the sensor.
(Fig. 22)
2168 - 002 - 28.11.2023
Before you assemble the
To prevent accidental start
Before you operate the
™
™
is a cloud solution that
™
sensor installed on the
™
sensor. For more
™
, refer to

Assembly

2. Put the upper handle in position on top of the lower
handle.
3. Attach the washer and the handle adjustment lever.
(Fig. 20)
4. Turn the handle to the side for a good operation
position when you operate the product near a wall.
(Fig. 21)

Operation

2. Remove the sensor.
3. Connect the battery to the sensor. The LED light of
the sensor comes on. (Fig. 23)
4. Download the Husqvarna Fleet Services
5. Log on to the Husqvarna Fleet Services
6. Do a pairing operation. Refer to
operation between the app and the product on page
13
To do a pairing operation between the app
and the product
1. Log on to the Husqvarna Fleet Services
2. Select your product in the app.
3. Scan the code behind the sensor with your mobile
device to install the sensor in the app.
Note:
It is only necessary to do a pairing operation
between the app and the product one time.
To install the sensor
1. Make sure that the sensor is connected to the
Husqvarna Fleet Services
pairing operation between the app and the product
on page 13 .
2. Drill 2 holes by the marks in the enclosure slot. (Fig.
24)
Note:
Make sure that the holes are the same
dimension as the rivets supplied with the sensor.
3. Use a pair of pliers to remove the outer holes on the
sensor slot. (Fig. 25)
4. Drill 2 holes by the marks in the sensor slot. (Fig. 26)
5. Align the sensor slot with the enclosure slot. (Fig. 27)
CAUTION:
Make sure that the wires
are not caught or become damaged.
To do a pairing
™
app. Refer to
™
app.
™
app.
™
app.
To do a
13