Husqvarna R419TsX AWD Workshop Manual page 64

CAUTION: Do not tighten the cables too much.
1. Do a check that the steering cables can be manually
moved 5 mm up or down on the steering collar.
2. Loosen the locknuts if the steering cables are too
loose.
3. Hold the cable with a wrench and tighten the
adjuster nuts.
4. Examine the cable tension.
5. Tighten the locknuts when the cable tension is
correct.
9.8.2 To replace the steering cable
A
1. Disconnect the adjuster nuts from the steering
cables (A). Hold the cables with a wrench when the
cables are attached to make sure that the cables do
not twist.
2. Remove the frame tunnel cover. Refer to
and install the frame tunnel cover on page 25 .
3. Disconnect the steering cable front connection (B) at
the steering chain (C).
4. Attach the new cable to the used cable if the used
cables are not cut.
5. Pull out the used cables from the frame to put the
new cables in the frame.
64 - Repair instructions
6. Make sure that the steering wheel is in the center
position when the rear wheels are in center position.
If not, reset the chain on the steering sprocket on the
steering column or adjust the steering cable.
9.8.3 To remove the steering cable pulley
1. Remove the frame tunnel cover. Refer to
and install the frame tunnel cover on page 25
2. Remove the locknut (A) and the adjuster nut (B) on
the rear ends of the steering cables.
3. Remove the screw (A) and the washer (B).
C
B
4. Remove the steering cable pulley (C) and the
bushing (D).
9.8.4 To replace the central steering unit
1. Loosen the rear ends of the steering cable. Refer to
To remove
To remove the steering cable pulley on page 64 .
2. Remove the steering wheel. Refer to
the steering wheel on page 10 .
3. Remove the front cover of the steering column.
Refer to
steering column on page 27 .
D
C
B
A
To remove and install the front cover of the
914 - 003 - 28.03.2019
To remove
B
A
To assemble