Husqvarna R419TsX AWD Workshop Manual page 27

9.1.1.13 To remove and install the transmission cover
1. Remove the 2 screws and remove the transmission
cover.
2. Install in opposite sequence.
9.1.1.14 To remove and install the top belt cover
1. Remove the screws that hold the top belt cover.
There are 1 screw on the each side of the product.
2. Remove the top belt cover.
3. Install in opposite sequence.
9.1.1.15 To remove the lower belt covers
1. Remove the screws that hold the lower belt cover.
There are 2 screws on the right side of the product
and the 3 screws on the left side.
2. Remove the lower belt cover.
3. Assemble in opposite sequence.
914 - 003 - 28.03.2019
X2
9.1.1.16 To remove and install the intermediate pulley
cover
1. Remove the right and the left footrest plate. Refer to
To remove and install the right footrest plate on
page 25 .
2. Remove the screws on the intermediate pulley cover
on the two sides of the frame tunnel.
3. Install in opposite sequence.
9.1.1.17 To remove and install the front cover of the
steering column
1. Remove the 2 screws and tilt the front cover of the
steering column forward.
2. Disconnect the wires.
Repair instructions - 27