Husqvarna R419TsX AWD Workshop Manual page 25

9.1.1.5 To remove and install the side cover of the
cutting deck
1. Remove the cutting deck. Refer to
install the front cover of the cutting deck on page 24 .
2. Remove the 2 screws (A) on the side cover of the
cutting deck.
A
A
3. Loosen but do not remove the screw (B).
4. Turn and remove the side cover of the cutting deck.
5. Install in opposite sequence.
9.1.1.6 To remove and install the equipment frame cover
1. Remove the cutting deck. Refer to
cutting deck on page 12 .
2. Remove the pin to remove the chain from the
equipment frame.
914 - 003 - 28.03.2019
To remove and
B
To remove the
3. Remove the 3 screws and remove the equipment
frame cover.
4. Install in opposite sequence.
9.1.1.7 To remove and install the frame tunnel cover
1. Move the seat rearward. Refer to
on page 10 .
2. Remove the 4 screws and remove the frame tunnel
cover.
3. Install in opposite sequence.
9.1.1.8 To remove and install the right footrest plate
1. Remove the frame tunnel cover. Refer to
and install the frame tunnel cover on page 25 .
2. Turn the knob on the rearward drive pedal (A) to
remove it.
3. Remove the 3 screws (B).
B
4. Loosen the edges of the footrest plate (C).
5. Remove the footrest plate.
6. Install in opposite sequence.
To adjust the seat
To remove
B
A
B
C
Repair instructions - 25