Husqvarna R419TsX AWD Workshop Manual page 49

3. Fill the new hydraulic oil filter with oil. Refer to
Technical data on page 72 .
4. Lubricate the seal of the new hydraulic oil filter with
engine oil.
5. Attach the hydraulic oil filter. Tighten by hand until
there is resistance, then tighten ¾ turn more.
6. Operate the equipment lift and the power steering.
7. Do a check that there are no leaks around the
hydraulic oil filter.
8. Do a check of the oil level in the hydraulic oil tank.
Fill with hydraulic oil if it is necessary. Refer to
Technical data on page 72 .
914 - 003 - 28.03.2019
9.5.11 To replace the hydraulic oil cooler
1. Open the engine cover.
2. Disconnect the plug of the hydraulic oil cooler.
3. Clean the hydraulic connections. Refer to
the hydraulic system clean on page 46 .
4. Make marks on the hydraulic hoses to make it easier
to connect them correctly when you assemble the
hydraulic oil cooler.
5. Disconnect the hydraulic hoses and put protective
caps in all hydraulic openings.
To keep
Repair instructions - 49