To Remove The Cutting Deck; To Do A Check Of The Parallelism Of The Cutting Deck - Husqvarna R419TsX AWD Workshop Manual

10. Push the lock handle down.
11. Set the lift lever for the cutting deck in the transport
position.
12. Move the weight transfer lever down to engage the
weight transfer.

4.8 To remove the cutting deck

To attach the cutting deck on
1. Do the steps 1–7 in
page 11 .
2. Pull and hold the lock handle.
12 - Assembly
3. Hold the front edge of the cutting deck and pull
forward while you hold the lock handle. Pull the
cutting deck to the end position.
Note: If you cannot pull the cutting deck to its end
position, release the lock handle and pull it up again.
4. Pull and hold the lock handle and lift the front of the
cutting deck until it releases. Lift until the front of the
cutting deck is released from the equipment frame.
5. Pull the cutting deck out.
4.9 To do a check of the parallelism of the
cutting deck
1. Make sure that the air pressure in the tires is correct.
Refer to Technical data on page 72 .
2. Park the product on a level surface.
3. Lower the cutting deck to mow position.
4. Set the cutting height lever to the first position.
5. Measure the distance between the ground and the
front and rear edges of the cutting deck. Make sure
that the rear edge is 4–6 mm (1/5") higher than the
front edge.
6. Adjust the parallelism of the cutting deck if it is
To adjust the parallelism of the
necessary. Refer to
cutting deck on page 13 .
914 - 003 - 28.03.2019