Husqvarna R419TsX AWD Workshop Manual page 57

4. Attach the front cable clamp for the hydrostatic
transmission.
5. Push the ball joint onto its bracket and attach the
locking spring.
6. Attach the ball joint onto the rear part of the
hydrostatic transmission cable. Turn the ball joint
10-12 turns until the ball joint is the correct length.
7. Pull the hydrostatic transmission cable along the
other cables.
8. Put the hydrostatic transmission cable in the rear
casing bracket and attach the rear clamp (B).
B
9. Adjust the hydrostatic transmission cable. Refer to
To adjust the hydrostatic transmission cable on page
57 .
10. Connect the rear ball joint (A).
914 - 003 - 28.03.2019
(10–12 x)
A
11. Put the locking spring into the hole (A) and push it
around the ball joint shaft (B).
A
12. Tighten the locknut for the rear ball joint.
13. Attach the frame tunnel cover. Refer to
and install the frame tunnel cover on page 25 .
14. Operate the product forward and rearward to make
sure that the transmission operates correctly.
9.5.16.3 To adjust the hydrostatic transmission cable
1. Disconnect the ball joint from the hydrostatic
transmission cable by removing the lock spring.
2. Make sure that the forward pedal is fully pushed.
3. Bend the arm to fully and do a check that the ball
and the ball socket in the ball joint align.
4. Adjust the ball socket on the cable until it is correctly
above the ball on the lever arm.
Note: Make sure the that locking spring goes
through the two holes in the ball socket.
5. Turn the ball socket two more times.
6. Assemble the ball joint and the locking spring for the
ball joint.
7. Tighten the locknut for the ball socket on the cable.
9.5.17 Transmission maintenance
9.5.17.1 To adjust the transmission neutral position
WARNING: Engine exhaust contains poisonous
carbon monoxide. Attach an exhaust hose
before you start the engine indoors.
1. Bleed the hydraulic system. Refer to
drive system on page 50 .
2. Put the product on the adjustment tool for wheel
Servicing tools on page 19 .
speed. Refer to
B
To remove
To bleed the
Repair instructions - 57