Interfaces; Overview - Siemens SINUMERIK 828D Manual

Spare parts/accessories
11.2 MCP 310C PN
LEDs
Table 11- 17 LEDs: Status display
Name Designation
H1 PowerOK
H2 PNSync
H3 PNFault
Note
When the system is booting, all three LEDs are lit.
Equipotential bonding
The equipotential bonding conductor is attached by means of an M5 screw.
11.2.3

Interfaces

11.2.3.1

Overview

Overview
X10
X20
X21
X30
X31
X51 / X52 / X55
X53 / X54
X60 / X61
S1
S2
100
Color Description
Green Lit: Power supply ok
Green Lit: System software running, STOP state
Flashes 0.5 Hz: System software running, RUN state
Red Not lit: Module is operating without errors; data exchange with all configured IO Devices
is running.
Lit: Serious bus fault; only output when one of the following errors is detected for the
ports:
No physical connection to a subnet/switch
•
Incorrect transmission rate
•
Full duplex transmission is not activated.
•
Power supply interface
PLC I/O Interface port 1
PLC I/O Interface port 2
Interface for rotary switch feed override
Interface for rotary switch spindle override / EMERGENCY STOP
(optional)
Interfaces for customer-specific inputs
Interfaces for customer-specific outputs
Reserved
Reserved
Switch for setting the MCP address
Manual, 06/2009, 6FC5397-2DP10-0BA0
PPU