Siemens SINUMERIK 828D Manual page 96

Spare parts/accessories
11.2 MCP 310C PN
Operator controls
● Operating mode and function keys:
● Feed control with override feed/rapid traverse (rotary switch with 23 positions)
● Key-operated switch (4 positions and 3 different keys)
Interfaces
● PLC I/O Interface (transfer rate: 100 MBit/s)
● 9 customer-specific inputs (e.g. for illuminated pushbuttons)
● 6 customer-specific outputs
Expansion slots
6 slots for control devices (d = 16 mm).
(additional cable set required for control devices, see section: "Accessories")
Key type:
Mechanical short-stroke keys.
96
– 49 keys with assigned LEDs
– Direction keys for milling machines with rapid traverse override
(key caps for direction keys for turning machines are supplied.)
For information, refer to section: "Control and display elements" → "Front side").
NOTICE
Handwheel connections
A maximum of 2 handwheels can be connected to the SINUMERIK 828D. They must be
wired directly with terminal X143 of the PPU.
Manual, 06/2009, 6FC5397-2DP10-0BA0
PPU