Siemens SINUMERIK 828D Manual page 117

Hole pattern for mounting the flange socket
Figure 11-23 Hole pattern for mounting
Flange socket
The mini HHU is connected to the PLC or the connector for handwheels via a flange socket.
The flange socket is part of the connection kit. The signals are sent to the NC in parallel.
There is no need for an additional distributor.
Figure 11-24 Flange socket
1. Insert the connector for the mini HHU connection cable in the detent lugs/guideways of
2. Tighten the screw cap.
PPU
Manual, 06/2009, 6FC5397-2DP10-0BA0
the flange socket.
Note
If the connector is connected incorrectly, the pins may be damaged.
Spare parts/accessories
11.3 Mini handheld unit
117