Siemens SINUMERIK 828D Manual page 5

Questions about this documentation
If you have any queries (suggestions, corrections) in relation to this documentation, please
send a fax or e-mail to the following address:
Fax
E-mail
A fax form is available in the appendix of this document.
SINUMERIK Internet address
http://www.siemens.com/sinumerik
CompactFlash cards for users:
● The SINUMERIK CNC supports the file systems FAT16 and FAT32 for
● Do not remove the memory card while it is being accessed. This can result in damage to
● If you cannot use a memory card with the SINUMERIK, it is probably because the
● Insert the memory card carefully and the right way round into the memory card slot
● Only use memory cards that have been approved by Siemens for use with SINUMERIK.
● The "CompactFlash® 5000 Industrial Grade" CompactFlash card from SanDisk has been
EC Declaration of Conformity
The EC Declaration of Conformity for the EMC Directive can be viewed/downloaded from the
Internet at:
http://support.automation.siemens.com
under the Product Order No. 15257461, or at the relevant branch office of I DT MC Division
of Siemens AG.
PPU
Manual, 06/2009, 6FC5397-2DP10-0BA0
+49 9131 98 2176
mailto:docu.motioncontrol@siemens.com
CompactFlash cards. You may need to format the memory card if you want to use a
memory card from another device or if you want to ensure the compatibility of the
memory card with the SINUMERIK. However, formatting the memory card will
permanently delete all data on it.
the memory card and the SINUMERIK as well as the data on the memory card.
memory card is not formatted for the control system (e.g. Ext3 Linux file system), the
memory card file system is faulty or it is the wrong type of memory card.
(observe indicators such as arrow or similar). This way you avoid mechanical damage to
the memory card or the device.
Even though the SINUMERIK complies with the general industry standards for memory
cards, it is possible that memory cards from some manufacturers will not function
perfectly in this device or are not completely compatible with it (you can obtain
information on compatibility from the memory card manufacturer or supplier).
approved for SINUMERIK (Order Number 6FC5313-5AG00-0AA0).
Preface
5