Technical Data; Gsm Modem - Siemens SINUMERIK 828D Manual

Procedure
Mounting an NX10 on an Active Line Module:
1. Remove the spacers from the NX.
2. Position the NX on the left-hand side of the Line Module. The mounting fixtures fit exactly
3. Push the two units together.
4. Press down on the NX until it engages and is securely connected to the Line Module.
11.5.6

Technical Data

Table 11- 51 Technical specifications
Parameters
Input voltage
Current (without DRIVE-CLiQ or digital outputs)
PE/ground connection
Dimensions (WxHxD)
Weight, approx.
Mounting position
11.6

GSM modem

Function
The SINUMERIK 828D can be equipped with a SINAUT MD720-3 GSM modem. This
optional hardware module makes it possible to exchange SMS messages with a cell phone
on the basis of the GSM standard.
In addition to error messages, it is also possible to transmit operating statuses such as the
machining processing level, tool wear limits or measuring process results. Using operating
screens, it is very easy to assign specific information to specific cell phones.
Please ensure that the antenna required for data transmission (supplied by the
manufacturer) is suitably located on the machine to achieve the best transmission/receiving
conditions. Connection to the SINUMERIK 828D uses an RS232 modem cable. Please note
that optimum transmission quality can only be guaranteed if the cable is no more than 3 m
long.
A SIM card is not included in the GSM modem scope of delivery. The user has to choose
their own cell phone contract.
Note
The SINAUT MD720-3 has two different operating modes. Only the terminal mode is used
with the SINUMERIK 828D.
PPU
Manual, 06/2009, 6FC5397-2DP10-0BA0
in the five cutouts on the NX.
Spare parts/accessories
11.6 GSM modem
Values
24 V DC (20.4 V - 28.8 V)
0.8 A
On housing with M5/3 Nm screw
(24.5 x 396 x 226) mm
1.5 kg
Vertical
147