Turret Drive Assembly; Turret Gear Box & Motor; Encoder Disk; Turret Position Sensor - Cornelius ABS 2.0 Service Manual

ABS 2.0 Service Manual
T D A
URRET RIVE
The entire turret assembly is attached to the motor coupler shaft by a pin/clip The 6-sided column at the top of the
turret shaft must align with the coupler shaft holes.

Shaft Coupler

Turret Position Sensor

T G B
URRET EAR OX
The gear box and motor are replaceable and are accessible from top side under the black cover of the ABS 2.0. Four
bolts attach them to the Gear/Motor bracket.
E D
NCODER ISK
The alignment disk, attached with three screws to the shaft coupler, interfaces with the turret position sensor and
notifies the Motion Control Board of which cup tube is at the extract position. The disk can only attach in one position.
T P
URRET OSITION
The turret position sensor is attached to the correct reads the holes in the disk sending position signals to the Motion
Control Board. The sensor can be replaced by removing the two screws that attach it to the bracket. The sensor is
electrically connected to the Motion Control Board.
S C
HAFT OUPLER
The shaft coupler not only joins the shaft to the gear box but it ensures alignment of the flats on the shafts necessary
for proper alignment communications to the Motion Control Board.
Publication Number: 621058590SER
SSEMBLY
& M
OTOR
S
ENSOR

Encoder Disk

Figure 81.
- 46 -
Turret Gear Box & Motor
© 2019, Cornelius Inc.