Initializing And Self Test - Cornelius ABS 2.0 Service Manual

ABS 2.0 Service Manual
I and S T
NITIALIZING ELF EST
Turn ON the ABS 2.0 unit at the ABS 2.0 ON/OFF switch located on the left top corner of the stand. During the
power-up sequence the Self Test and Initializing messages will be displayed as each test is being made. When
the tests are complete the final message will be displayed.
Figure 3.
If the Initialing process ends with a "No COM System Ports Found" see message, it means that the communication
cable between the POS system and ABS system is not connected. If it is not convenient to connect the cable at this
time but you wish to proceed with the Set Up, Choose CLOSE WINDOW from screen to bypass the Failed
message.
© 2019, Cornelius Inc. - 7 - Publication Number: 621058590SER