Last Cup Sensor - Cornelius ABS 2.0 Service Manual

L C S
AST UP ENSOR
A sensor is located near edge of the sink, in the serving area. This sensor ultrasonic through the cop holder in Cup
Serve Point "A" position (see Figure 73.). When a cup or anything else is present in that holder that blocks the
ultrasonic wave, the carousel is halted until it is removed.
When a cup reaches the Cup Serve Point "A" it cannot be allowed to rotate any farther since the next position is the
extract position. Therefore, once a cup reaches Cup Serve Point "A", the ABS will stop operating until that cup is
removed. If, for example, there were cups at Cup Serve Positions; "A" and "B", and the cup at Point "A" was removed
the carousel would rotate one space until the cup that was at Point "B" moves to Point "A", then the ABS 2.0 would be
stopped again.
The carousel mechanization assembly consists of: a drive motor, gear box, drive sprocket, idler sprocket, carousel
belt with cup holders attached, and drive belt cover with 3 thumb screw fasteners.
Cup positioning
bracket must be at
the rear and down
Cup slide

Last cup sensor

Drip tray
© 2019, Cornelius Inc.
Figure 73. Carousel Assembly
- 39 -
ABS 2.0 Service Manual
Carousel drive
Publication Number: 621058590SER