Yamaha VK540EF Assembly Manual page 24

Set up point
1. Fit the handlebar assembly 1 to the handle-
bar upper holder 2 and lower holder 3 us-
ing the bolts with spring washers 4 .
NOTE:
D Temporarily tighten bolts 4 to the handlebar
holder.
D The upper handlebar holder should be
installed with the punched mark A forward.
2. Tighten the handlebar bolts 4 and maintain
an equal gap on each side of each holder.
CAUTION:
Be sure the small gap "a" side of the holder
faces forward.
3. Clamp the throttle cable and wire harness
with the band 7 .
4. Install the upper steering pad 5 with the
handlebar using screws 8 and the lower
steering pad 6 to the handlebar using bolts
9 , spring washer
NOTE:
D Be sure the hooking C to the handlebar D .
D Be sure the hooking E to the upper steering
pad F .
2-6
10 and washer 11 .